Welcome To STRONG H MACHINERY TECHNOLOGY CO.,LTD. !

News Center

Contact us

Contact: Nancy

Phone:13583556230

Tel:86-535-2292508

E-mail:nancy@strongh.cn

Address:No. 1699 Kaiming Road, Laizhou Development Zone, Shandong Province, China

Home > News > Industry News

How to debug the automatic inner ear mask machine?

Release time: 2020-08-14

Views: 1055

How to debug the automatic inner ear mask machine?

Mask machines can be divided into inner ear mask machines, outer ear mask machines, and band-type mask machines according to the different positions of the ear straps of the finished masks manufactured. Although the outer ear mask machine has become the choice of many businesses, the inner ear mask machine also occupies a part of the market.

 

Today, Strong H Machinery Manufacturing Co., Ltd. will introduce you the debugging method of the fully automatic inner ear mask machine:

 

Flat mask making machine


The full-automatic inner ear mask machine uses ultrasonic welding. When the mask is turned to the processing position, ultrasonic waves are automatically generated, which generates micro-amplitude and high-frequency vibrations on the ear straps, which are quickly converted into heat, melt the material to be processed, and then make the ears The tape is permanently pasted or embedded on the inside of the mask body. It is a processing process for the production of inner ear masks. Only one administrator needs to place the mask body piece by piece in the mask tray. The subsequent actions are automatically operated by the equipment until the end of the finished product.

 

1. Turn on the start-stop switch and the power switch, the built-in light of the power switch is on.

 

2. Adjust the air pressure. The air pressure valve is under the operating table. You can find the air pressure valve by opening the door of the equipment. Adjust the pressure according to the specific situation. When some mechanisms are not synchronized, increase the pressure. The operating air pressure is generally at Adjust within the range of 0.2~0.6MPa.

 

3. When the equipment is stopped, turn on the power switch of the ultrasonic generator and press the "Sound Wave Test" switch. If the amplitude indicator indicator rises sharply and exceeds 100, it means that the frequency is too far from the resonance point and the "Sound Wave Adjustment" knob must be adjusted. Look at the amplitude indicator, press the "Sound Wave Inspection" detection switch with the left hand (not more than 3 seconds), and turn the "Sound Wave Adjustment" knob with the right hand to adjust the amplitude indicator pointer to the low point. When adjusting, if the amplitude indicator indicator does not fall but rises, turn the "sound wave adjustment" knob in the opposite direction. The reading of the amplitude indicator indicator is within 50, and the reading of the ammeter indicator is below 0.6A, which is a better working condition. After adjusting the sound wave, tighten the butterfly nut and close the protective cover.

 

Ear loop attaching machine


4. the inspection of the cooling fan, to detect whether the cooling fan is running normally, to ensure that the ultrasonic transducer can run for a long time while it is working.

 

Looking for a reliable Chinese mask machine manufacturer? Strong H Machinery Manufacturing Co., Ltd. is your best choice!